CLEVERCOAT™ PU 640 TC 2K is a colored, two component, PU-based, aliphatic top coat coating material with high UV resistance. It forms a seamless, brightly colored and very scratch resistant film. Thanks to its aliphatic structure, it preserves its color when exposed to sunlight, does not fade or turn yellow.
All kinds of surfaces where high abrasion resistance is required
Areas exposed to pedestrian traffic
Stadiums
Industrial floors
Indoor and outdoor car parks
Roof, terrace, patio and balconies
Top coat of epoxy floor coatings
Surfaces requiring high wear resistance
It can be applied as a top coat material to increase the UV resistance of all Polyurea, polyurethane and epoxy coating and insulation materials
Easy to apply (by brush, roller or spray)
It has UV resistance
Thanks to its aliphatic structure, it preserves its color when exposed to sunlight, does not fade or turn yellow
It provides excellent adhesion and adhesion to the surface
When applied, it provides a one-piece film layer that does not cause joint or leakage
It is resistant to continuous water contact
Preserves its mechanical properties between -40°C and +80°C
It has excellent chemical resistance
Surface Preparation:
The surface to be treated shall be cleaned from adherence and adhesion weakening factors such as oil, grease, paraffin waste, cement grout, loose particles, mold release agents, cured old membranes. If necessary the surface shall be washed with high pressure water jet, and be thoroughly dried. Surface defects such as cracks, unevenness etc should be repaired with suitable products.
Priming :
The prepared surface should be primed with CLEVERPRIME™ PU PRIMER 200
Product Application :
Before using, the package should be opened and mixed with a low speed mixer for 2-3 minutes. The products should be applied @ 0.15 – 0.20 kg/m2 with a roller or brush until the entire surface is covered, at least in two layers. If air is entrapped into the material, visible air bubbles will occur after the material is cured on the
floor. The material is poured over the primed surface and spread over the entire surface with the help of a roller or brush.
Apply polyurethane based liquid waterproofing membrane CLEVERCOAT™ PU 640 TC 2K @ 0.15 – 0.20 kg/m2 on primed surface after necessary surface preparation.
For more details and technical proposals click here to contact
CLEVER CUSTOMER SUPPORT.
28/6, Natesh Building
100 Feet Bypass Road, Velachery
Chennai – 600 042 India.
‘Thamarai’ A32, Shantiniketan
City Link Road, Adambakkam
Chennai 600088, India
1st Cross Street,
Balaji Nagar (East), Ambattur
Chennai – 600053, India
© 2023 Rayar Infra Private Limited. All Rights Reserved.
